Hoyt 38 Ultra Specifications
Below are the specs for the Hoyt 38 Ultra compound bow. This compound bow was modified by the Hoyt design team over years. Scroll down to find Hoyt 38 Ultra specs for all modifications.
2 versions (2007), specs were changed
all versions (2007)
specific version
specific version
| Version | Brace height | Ata length | Draw length | Draw weight | IBO speed | Mass weight | Let-off |
|---|---|---|---|---|---|---|---|
| BH | AtA | DL | DW | IBO | Wght | LO | |
| Version: 2007 Ultra XT 1000 (Vector cam) | |||||||
| 2007 Ultra XT 1000 (Vector cam) | 7.5 " | 38 " | 27-32 " | 40-80 lbs | 310 fps | N/A lbs | 65% or 75% |
| Version: 2007 Ultra XT 1000 (Cam & 1/2) | |||||||
| 2007 Ultra XT 1000 (Cam & 1/2) | 7.25 " | 38 " | 27-32 " | 40-80 lbs | 300 fps | N/A lbs | 65% or 75% |
| BH | Brace height |
| AtA | Axle-to-Axle length |
| DL | Draw length |
| DW | Draw weight |
| IBO | IBO speed |
| Wght | Mass weight |
| LO | Let-off |
What do you want to do next?
Check Out Pros & Cons
Pros
Pros
- Hotter Vector Cam and a half pairs a smooth draw with a 310 fps IBO, giving the long 38-inch chassis more speed than the accuracy-tuned 38 Pro without going to an aggressive hunting cam
- Long 38-inch axle-to-axle with a 7.5-inch brace keeps the bow forgiving and steady while shaving enough brace height to pick up velocity - a genuine all-around geometry
- StealthShot string suppression and RizerShox came standard, so a used 38 Ultra shoots quieter and deader in the hand than most bare-riser bows of 2007
- Selectable 65 or 75 percent let-off by draw-stop peg lets a shooter set a firm target hold or a more relaxed one on the same bow
- Wide 40 to 80 pound range on the machined TEC riser and laminated XT1000 limbs makes one used chassis fit almost any adult setup from range to woods
- Built for a single model year in 2007, so used examples are scarcer than the three-year 38 Pro and finding your exact draw and weight can take patience
- Any 2007 bow needs a condition-based string and cable judgment - a fresh set and a re-time is the standard first step and brings the draw and speed back to factory
- Draw-length changes run through the module and limb setup, not a tool-free rotating module, so confirm the draw at a shop before buying a used example