Darton Tempest E 3D Specifications
Below are the specs for the Darton Tempest E 3D compound bow.
2 versions (2022-2021), specs were not changed
all versions (2022 - 2021)
specific version
specific version
| Version | Brace height | Ata length | Draw length | Draw weight | IBO speed | Mass weight | Let-off |
|---|---|---|---|---|---|---|---|
| BH | AtA | DL | DW | IBO | Wght | LO | |
| Version: 2022 | |||||||
| 2022 | 6.5 " | 36 " | 25-30 " | 40-70 lbs | 320-325 fps | 5.1 lbs | 85% |
| Version: 2021 | |||||||
| 2021 | 6.5 " | 36 " | 25-30 " | 40-70 lbs | 320-325 fps | 5.1 lbs | 85% |
| BH | Brace height |
| AtA | Axle-to-Axle length |
| DL | Draw length |
| DW | Draw weight |
| IBO | IBO speed |
| Wght | Mass weight |
| LO | Let-off |
What do you want to do next?
Check Out Pros & Cons
Pros
Pros
- Forgiving at full draw - the E-System roller-and-yoke equalizes limb stress and offloads the cam bearings, and the platform settles and holds the pin with unusual calm
- Rock-solid back wall - the big cable-stop pad hits with no sponginess, and an optional limb stop gives a second, even firmer wall
- Heavy, planted hold - the machined 7075 riser and matching 7075 cams on wide 0.790-inch pockets keep the sight still while you aim
- Deep tuning for the money - 85 percent adjustable let-off, valley-shortening spacers, and combinable limb-stop and cable-stop setups let you shape the back half of the shot
- The square machined grip is polarizing - some shooters take to it immediately while others find the flat profile unusual at first; thin grip tape or stick-on side plates reshape the hand feel if it does not suit you
- Paint, not anodize - the painted riser can pick up finish runs or lift under repeatedly applied grip tape, so inspect the sight-screw holes on setup and leave grip wrap in place once it is on